The AVANTONE
“Cabernet (C-series)” mics from AVANT
ELECTRONICS are designed to offer true
professional performance. They will meet or
surpass the performance and specifications
of much higher priced mics.
The AVANTONE
CK-7 is truly a gorgeous looking and
sounding microphone. The design, character
and performance can be compared directly to
some of the very finest FET mics…but
at a fraction of their cost!
Our rugged
CK-7 microphone body and capsule assembly
are precision machined of BRASS.
Aesthetically, it features an elegant
Metallic Cabernet Wine-Red finish, accented
with polished nickel trim and grill.
The
transformer coupled Discreet Class A FET
circuitry will yield pleasing professional
results comparable to much more expensive
designs.
Any studio
can proudly offer the CK-7 as a vocal mic or
utility condenser due to its versatility…It
exudes class visually as well as sonically.
Manufactured
using the finest materials yielding a very
solid feel, superb structural integrity and
rugged reliability.
The versatile CK-7 mic is
able to produce professional results with a
warm, pleasing sonic character.
The included Custom Retro
Shockmount is superb in allowing a precise
positioning of the mic while inhibiting the
transfer of unwanted vibrations up into the
mic. This isolation allows for superior
professional results.
3-Pattern
CLASS A FET Microphone w/ dual 35mm gold
sputtered thin Mylar capsules
-10
dB pad & 80 Hz LF roll off switches
Standard
Included Items:
AVANTONE
CK-7 Multi-Pattern FET Microphone
AVANTONE
Custom Retro Shockmount
Elegant
padded genuine wooden Mic box
Padded Aluminum storage / travel case
Owners Manual
Uses Include:
Studio vocals, acoustic guitar,
mandolin, drum overheads, piano, room
mic, etc…
The 3 patterns allow the CK-7 to be used
in a variety of situations. The cardioid
pattern is generally best used on vocals
and single instruments. The omni mode
works well in incorporating some room
sound into the track. The figure 8
pattern allows 2 vocalists to use the
mic at the same time from opposite
sides.
The -10dB attenuation switch can be
engaged when miking very high SPL
sources to keep from overloading the
electronics.
The 80Hz HIGH-PASS filter switch can be
engaged to reduce rumble and to keep
unwanted low frequencies from “muddying
up” the track.
|
Type: |
True Condenser |
|
Polar Pattern/s: |
Cardioid , Omni
, Figure 8 |
|
Frequency Response: |
20-20,000 Hz +/- 3dB |
|
Output Impedance: |
<=250 Ohms |
|
Maximum SPL : |
139dB (0.5% THD @1000Hz) |
|
S/N Ratio re 1Pa :
|
75dB |
|
Output Connector: |
Male XLR 3 pin |
|
High-Pass Switch |
80 Hz 6dB/octave |
|
Attenuation Switch |
-10 dB |
|
Power Requirement: |
Standard 48 Volt Phantom |
|
Included Accessories: |
Wooden Box & Shockmount,
Metal Road case |
|
Finish: |
Polished Nickel trim /
Metallic Cabernet Red Body |
|
Weight: |
.65
kgs / 1.4 lbs |
|
Dimensions: |
187mm x 51mm /
7.5" x 2" |
